S-GA FUEL DISPENSER

S-GA FUEL DISPENSER

Pump Type :Optional

Inlet Pressure :>=54kPa.

Flow rate (L/min.) :55±5

Suction Distance (m) :6(verticalmente) / 50(orizzontalmente)

FlowMeter Type : Optional

Accuracy :±0.2%

Motor Voltage(V) :110V/220V/380V,50Hz/60Hz

Capacity(hp) :1HP(0.75kw)

Input Voltage : 110V/220V/380V,50Hz/60Hz

Nozzle :Auto Shut-off Nozzle

Environmental Condition: -40~~+55degree

Control Type : Solenold Vale Control Type

Preset : Function Provided(Small LCDIndicator)

Display(Counter) :Type LCD and Bright Backlight

Digit of Volume : 0~~999,999(6 Digits),Decimal point can be changed

Digit of Amount :0~~999,999(6 Digits),Decimal point can be changed

Digit of Unit price : 0~~9999(4 Digits),Decimal point can be changed

Digit of Total Range : 0~~99,999,999,99

Optional Display :Type LCD and Bright Backlight

Digit of Volume: 0~~99,999,999(8 Digits),Decimal point can be changed

Digit of Amount :0~~99,999,999(8 Digits),Decimal point can be changed

Digit of Unit price : 0~~999999(6 Digits),Decimal point can be changed

Digit of Total Range : 0~~99,999,999,99

Totalizer: 1~~9,999,999

Hose :4.5m

Weight : 285kg.

Dimension(L×W×H) :1160*560*2215(mm)

Dimension(L×W×H)Of Qty of Container: 40ft: 27

inlet of pump. Vapor segregated device: key component of vapor separator. It includes the following components ---High pressure chamber composed of frame and upper cover; vapor segregated chamber that used to be called general pressure chamber, due to vary along with pump pressure, returned oil floater being installed here; sp fuel dispenser heriform buoy with exhausting valve, exhausting valve seat, returned oil floater, returned oil valve and exhausting pipe. Some factories evolve the spheroid buoy with exhausting valve and exhausting seat as a ball valve, illustrating in diagram 2-15. Now some manufacturers replace ball valve with other structure that promotes the separator capacity. Diagram 2-14 Dimensional structure drawing of vapor separator 1-Valve cover 2-Vavle body 3-Steel ball 4-Upper cover Diagram 2-15 Structural drawing of single direction valve This kind of vapor segregated device has large pressure chamber in which oil flow slowly so that vapor has time upward. Therefore, this kind of vapor separator is better than that of small pressure chamber in terms of separate capacity. Anti-backward flow device: it mainly composes of spring seat, spring, check valve unit and outlet pipeline. Check valve gasket is made of oil-resistance rubber board, which is very important for realizing anti backward flow function. Working principle After starting a new fuel dispenser larger air in pipeline is impelled out through check valve and exhausting valve. As there is no foam found in oil indicator fuel dispenser would be refueled. Fuel contained foam flows out of check valve through the bottom of high pressure chamber. The floater in high pressure is upward, levels of exhausting valve and its seat at parallel height, floated air and rest of oil flow into vapor separator chamber from the groove of exhausting valve. If that is ball valve, the steel ball has covered the hole on valve cover, these air and flow only flow from the groove of ball valve. The mixture of oil and air flow into vapor separator chamber in fuel dispenser fuel dispenser

ctrical systems i EN 50039 A A A　　 General requirements for Category 1 EN 50284 A　　 equipment　　 General requirements fuel dispenser EN 50014 A A A　　 A = allowed　　 48　　　　　　 Annex ZA　　 (informative)　　 Clauses of this European Standard addressing essential requirements or　　 other provisions of EU Directives　　 This European Standard has been prepared under a mandate given to CEN by the European Commission and the　　 European Free Trade Association and supports essential requirements of EU Directive.　　 The following clauses of this standard are likely to support requirements of Directive:　　 rd　　 Directive 949EC of the European Parliament and the Council of 23 March 1994 on the approximation of the laws　　 of the Member States concerning equipment and protective equipment intended for use in potentially explosive　　 atmospheres.　　 Compliance with the clauses of this standard provides one means of conforming with the specific essential　　 requirements of the Directive concerned and associated EFTA regulations.　　 WARNING : Other requirements and other EU Directives may be applicable to the products falling within the scope　　 of this standard.　 fuel dispenser fuel dispenser

in the British edition of The Economist International Nuclear-weapons proliferation Going critical, defying the world Sanctio fuel dispenser ns History lessons Islam and the Vatican An invitation to talk business Advertisement Classifieds Sponsors feature About sponsorship » Jobs Business Tenders Jobs Tenders Jobs Consumer Senior Anti- Technical Advice to ADVISER Science City Chief Executive Corruption Specialist the National Statistics DECENTRALISATION International Officer WSI Internet - Start We are an Office RESEARCH Sustainability for A Rocha Your Own Business internationally Technical Advice to (PNGASF 58 2-107) Competition International to lead A Business Opportunity operating the National Statistics National Research Science City Rocha s strategic and - WSI Internet Start competence centre Office The Depa.... Institute Port Internationa fuel dispenser fuel dispenser